Audi 80/Avant (B4)



Audi 80/Avant
The description
Engines
System of release of the fulfilled gases
Cooling system
Fuel tank and the fuel pump
The air filter and intake channels
Injection system
Coupling
Transmission and transmission
Suspension bracket and steering
- Brake system
   Check of brake mechanisms
   Brake liquid
   Check of level of a brake liquid
   Check of tightness of brake system
   Replacement of a brake liquid
   Disk brake mechanisms
   Measurement of a thickness pads the disk mechanism
   The control of a condition of brake disks
   Replacement pads disk brake mechanisms
   The drum-type brake mechanism
   Measurement brake pads the drum-type mechanism
   Check of a course of a pedal of a brake
   The disk brake mechanism of back wheels
   Measurement of a thickness pads back disk brakes
   Check of a free wheeling of the lever of a lay brake
   The main brake cylinder
   The amplifier of brakes
   Check of the amplifier of brakes
   Regulator of brake forces
   Repair of a hydraulic drive of brakes
   Prorolling of brake system
   The list of malfunctions
Antiblocking system of brakes
Wheels and tyres
body electrosystem
Ignition system
Illumination
Signalling devices
Devices and auxiliary devices
Heating and ventilation
Body elements
Search of malfunctions
Specifications












The disk brake mechanism of back wheels

Except for the model capacity of 66 kw which have been not equipped АБС, 92 let out till October, on the back bridge are established disk brake mechanisms instead of the drum-type. It is a question, as well as in a case with brakes of the forward bridge, about disk brake mechanisms with floating bracket.

In addition to a hydraulic drive through a brake pedal the disk brake mechanism can be served also тросовым by a drive of system of a lay brake. The lever on which the corresponding cable is fixed, puts in action a pusher which the brake piston nestles to колодкам.

Automatic control

Designs of disk brake mechanisms in the car are always carried out by the self-regulated: with increasing deterioration brake pads the brake piston simply leaves further a support of the disk brake mechanism, providing with that dense прилегание brake pads to a brake disk. Owing to filling of the added volume in the cylinder a brake liquid formation backlash is impossible.

On another it occurs in a mechanical drive of lay brake system: here press the drive pusher at some instant time simply could not get the coming to light piston if there was no adjusting device. It "extends" a pusher as required. The basic part of regulation is a carving, on which depending on deterioration pads all further forward наворачивается a pusher part. The press device thus becomes longer. Therefore at replacement pads it is impossible to push simply back the brake piston, it turn off back on the adjusting device.