Audi 80/Avant (B4)

Replacement wedge a belt

So полиwedge the belt is put on a pulley at the models equipped with the conditioner.

In drawing passage semi wedge a belt at the model which have been not equipped with the conditioner is displayed.

PERFORMANCE ORDER

New wedge the belt in no event cannot be "worn out" on pulleys by means of a screw-driver because arising cuts, so to say, predetermine the following breakage of a belt.
To weaken an old belt for replacement.
Now it is possible to remove easy it from pulleys, and the new belt can be put on them conveniently.
Pay attention: if necessary it is necessary to remove and others клиновые belts, or you will need to disconnect a forward support of the engine.
In summary to pull belts, to pass about hundred kilometres and then донатянуть.
What wedge where should be put a belt in Audi 80, you learn from the table above.

Replacement semi wedge a belt on models with the 6-cylinder engine

PERFORMANCE ORDER

To remove a casing semi wedge a belt.
To establish накидной a key of 15 mm on шестигранник the tension device and to take away it to the right (bolts with зведчатой a head are sometimes established).
To insert a pin (for example suitable bolt, etc.) in the aperture provided for this purpose and by that to fix the tension device.
To note a direction of rotation of a belt a chalk or a felt-tip pen.
To remove полиwedge a belt.
At installation to put полиwedge a belt at first on driving and directing rollers; in last turn on a tension roller.
Again to raise the tension device a key and to remove a pin.
To establish a casing.