Audi 80/Avant
The description
Engines
System of release of the fulfilled gases
Cooling system
Fuel tank and the fuel pump
The air filter and intake channels
Injection system
Coupling
Transmission and transmission
Suspension bracket and steering
Brake system
Antiblocking system of brakes
Wheels and tyres
body electrosystem
Ignition system
Illumination
Signalling devices
Devices and auxiliary devices
Heating and ventilation
- Body elements
Forward bumpers
Forward part of the car
Cowl
Wings
Молдинги
Doors
External rear-view mirrors
The forward and back has flown down
Cover of a luggage carrier at a sedan
Back door of the versatile person
Back bumper
The sdvizhnoj hatch
Procleaning of apertures for a water drain
The control of anticorrosive protection of the bottom of a body
Salon
Seats
Search of malfunctions
Specifications
|
Wings
|
|
The wing (3) is presented in drawing together with hinged details:
1 – a back face overlay;
2 – подкрылок. |
Demountable forward wings are executed only. Back wings are welded, here again there is nothing to do to mechanics-fans.
Removal of facing of forward wheel niches
|
|
- To remove a corresponding forward wheel.
- To remove plastic дюбель at the very bottom on back to bumper edge.
- To remove sidewallsы a bumper from arms on a wing. For this purpose to press on a bumper in a direction downwards at height of fixture and simultaneously to take away it from a body.
- To turn away all fixing bolts/nuts of facing of a wheel niche (подкрылок).
- To remove plastic дюбели a forward bolt.
- In front to turn away a fixing nut подкрылка.
- To turn a rotary lock on connection with the bottom protection of a motor compartment on 90 counter-clockwise (to the left).
- To remove facing of a wheel niche through распорный a bolt and to wring out inside from an external contour of a wheel arch.
- At installation very cautiously to tighten plastic nuts and bolts with crosswise шлицем, differently it is possible to break a plastic carving!
|
|
Wing removal
|
|
- To remove подкрылок.
- To remove a bumper.
- To turn out on bottom to wing edge on one screw with crosswise шлицем or screws with звездчатой a head in front and behind.
- To turn out the screw below cut for a bumper.
- In a back part of a wheel niche to turn out the screw from a cross-beam, and one more a bit more low.
- To open a forward door.
- To turn out a bolt over hinges.
- To turn out шестигранные bolts on a wing upper edge; before it to remove поролонную a lining.
- To remove a wing.
|
|
Installation covered
|
|
- If the new wing is established, it is necessary to remove an arm and a back face overlay from an old wing and приклепать (in a workshop) to the new.
- To remove the rests of a sealing tape on back edge of fastening of a wing.
- To paste a new sealing cord (number spare parts AKD497 010 04R10) diameter 7 mm.
- To establish a wing.
- To establish distance to a cowl at not tightened fixing bolts of an upper edge of a wing. It should make 4,5—5,5 mm.
|
|
|
|