Audi 80/Avant
The description
Engines
System of release of the fulfilled gases
Cooling system
Fuel tank and the fuel pump
The air filter and intake channels
Injection system
Coupling
Transmission and transmission
Suspension bracket and steering
Brake system
Antiblocking system of brakes
Wheels and tyres
body electrosystem
Ignition system
Illumination
Signalling devices
Devices and auxiliary devices
Heating and ventilation
- Body elements
Forward bumpers
Forward part of the car
Cowl
Wings
Молдинги
Doors
External rear-view mirrors
The forward and back has flown down
Cover of a luggage carrier at a sedan
Back door of the versatile person
Back bumper
The sdvizhnoj hatch
Procleaning of apertures for a water drain
The control of anticorrosive protection of the bottom of a body
Salon
Seats
Search of malfunctions
Specifications
|
Back bumper
|
|
For removal of a back bumper it is necessary to weaken on the right and left parties of the car on two шестигранных a bolt. On an illustration fixing bolts of a sedan are shown. |
|
|
If the cover of a luggage carrier of a sedan knocks or sits incorrectly, it is possible to adjust locking plate (3) behind at a floor of a luggage compartment. For this purpose it is necessary to weaken both screws (arrow). The locking plate becomes an accessible covering after removal of loading edge (1) or after removal of a small cover (2) in a covering. |
Removal
|
|
- The version a sedan: to cast away a rug of a luggage compartment.
- The version the versatile person: to remove behind a door covering.
- To cast away a rug of a luggage compartment.
- To remove from clamps a lateral covering of a luggage compartment – only behind.
- Slightly to delay aside a lateral covering, to enter from above between a covering and a back wing a face key with the extension piece (length about 500 mm) with a replaceable head and карданом and to put on it fixing bolts of a bumper.
- To turn out bolts.
-
All models: to turn out in a luggage carrier on the right and at the left on two шестигранных a bolt.
- To turn out on the right and at the left on two screws-samoreza, connecting a bumper and подкрылок.
- To separate lateral faces of a bumper from body arms.
- For this purpose strongly to press a bumper sideways downwards and simultaneously to delay it for an upper edge from a body.
- To remove a bumper, raising on both ends over подкрылками.
- At bumper installation at first to insert back fastenings.
- Bumper lateral faces at first to insert into arms on a body a bottom edge. Then to press them sideways above that the top fixing points were fixed also. To watch for fixing bracket on a bumper bottom edge.
- To lift подкрылки over the ends of a bumper and to connect their bolts.
-
The versatile person: bumper regulation on height is made by moving of fastening of a bumper. The distance between a bottom edge of lateral back wings and a bumper should make 6,5–7,5 mm
|
|
|
|