Audi 80/Avant (B4)



Audi 80/Avant
The description
Engines
System of release of the fulfilled gases
Cooling system
Fuel tank and the fuel pump
The air filter and intake channels
- Injection system
    System of injection Mono-Motronic
    System of injection Digifant
    System of injection KE-III-Jetronic
   - Systems of injection MPI and MPFI
      Operating procedure
      Ljambda-regulation
      Malfunctions and independent diagnostics
      Independent repair
      Visual check
      Check of separate elements
      Removal of elements
      Trosovyj drive of "gas"
      Check of a mode of idling and the analysis of exhaust gases
      The list of malfunctions
Coupling
Transmission and transmission
Suspension bracket and steering
Brake system
Antiblocking system of brakes
Wheels and tyres
body electrosystem
Ignition system
Illumination
Signalling devices
Devices and auxiliary devices
Heating and ventilation
Body elements
Search of malfunctions
Specifications












Visual check

 PERFORMANCE ORDER

  1. To begin with check up air lines on tightness! All hoses – from a thick sleeve of an air inlet to thin vacuum hoses should be checked.
  2. Whether as it should be sealing linings впрыскных atomizers, and also фланцевые linings of inlet channels?
  3. Not tight places open access to not considered air, that is air which is not considered by system and consequently essentially disturbs to mix preparation. The mix неконтролированно is impoverished. A consequence of it are malfunctions in the engine work, shown first of all in rough idling.
  4. To warm up the engine to working temperature, then to leave to work on single turns, to open a cowl, to separate plug connection to a ljambda-probe.
  5. To sprinkle from a spray containing starting fuel (for example Startpilot) sealing фланцевые linings of inlet channels and other details inspiring suspicion.
  6. If frequency of rotation changes at spraying of a certain place, means, there has arisen негерметичность.
  7. Whether it is possible to distinguish негерметичность топливопроводных hoses?
  8. Whether tips of wires have been repeatedly separated and again connected? Corrosion or inept actions can lead to insufficient contact.
  9. Attentively consider tips of separate components of system of injection. They can be processed only a contact spray, but not to bend at all that can cause malfunctions.