Audi 80/Avant
The description
Engines
System of release of the fulfilled gases
Cooling system
Fuel tank and the fuel pump
The air filter and intake channels
Injection system
Coupling
Transmission and transmission
Suspension bracket and steering
Brake system
Antiblocking system of brakes
- Wheels and tyres
Wheels
Wide tyres and wheels
Pressure check in tyres
The control of a condition of tyres
Wheel replacement
The control of an inhaling of wheel bolts
Balancing of wheels
Purchase of new tyres
body electrosystem
Ignition system
Illumination
Signalling devices
Devices and auxiliary devices
Heating and ventilation
Body elements
Search of malfunctions
Specifications
|
Wheel replacement
|
|
If the serviceable wheel balanced on the car – for example after the control of a condition of brakes it needs to be tightened on a wheel nave in the same position, as before removal is established. For this purpose it is necessary to note position on a rim (2) and a nave of a wheel (1). |
Wheel replacement in a way – not absolutely simple business. Bolts for wheel fastening can appear приржавевшими or at last replacement of wheels in a workshop them "have slammed" shock гайковертом (instead of as it is necessary to tighten the moment 110 Nm). In this case the onboard tool will not help you, the powerful key for an inhaling of bolts of fastening of wheels or крестовидный a key with the put on piece of a pipe for lengthening of the lever of force is necessary.
|
|
- To put the car on a lay brake and to include the first either a reverse gear or parking blocking.
- On road to include the emergency light alarm system and to establish a sign on an emergency stop.
- To block opposite side wheels, for example stones or wooden брусками that they did not move.
- Insert fingers into apertures of a wheel cap and remove it.
- If on the car stand легкосплавные wheels with secret fastening insert a screw-driver into lateral dredging on a cap and remove a cap.
- Open a key "a confidential" bolt for fastening of wheels if that costs on your car.
- To weaken bolts for fastening of wheels – everyone approximately on a turn.
- To establish an onboard jack on the basis of the car скосом inside on the designated place of a bottom edge of a body (section the workplace Organization). The jack should enter thus in vertical распорку bodies.
- On the soft earth it is necessary to enclose a plate under a jack.
- To lift the car.
- Completely to turn out bolts for wheel fastening.
- To remove a wheel, to put on a spare wheel. The aligning pin from an onboard tooling if it before wheel installation to screw in a bolt aperture thus can help.
- To put консистентную or liquid greasing on a cone and a carving of a bolt for fastening of wheels.
- In regular intervals and перекрестно to tighten bolts. Thus to turn a wheel that in one, in other party that it was faultlessly aligned on a nave.
- To lower the car, дозатянуть bolts (110 Nm).
- To put on a cap. To pay attention to cut for a tyre nipple.
- After a short trip to check up strong landing of bolts.
|
|
|
|
The help: if bolts for fastening of wheels cannot be screwed in a wheel nave the brake disk turned on a nave can be the reason. Turn it until apertures will coincide.
|
|
|